EE-AT Build Guide

Introduction

  • Layout - WKL, WK
  • Materials - 6063 Aluminum, Copper, Brass
  • Typing Angle - 4 Degrees
  • Front Height - 19.25mm (without lip)
  • EKH - 23.09mm
  • Weight - 2.8kg Unbuilt

Standard Screws and Hardware

This hardware can be purchased at many online retailers by searching the name below should any replacements be necessary.
  • M2.5 x 0.45 - 6H 8mm, socket head screws are used for the front edge case screws
  • M2.5 x 0.45 - 6H 12mm, socket head screws are used for the back edge case screws
  • M2 x 0.4 - 6H 4mm, socket head screws are used for the daughterboard
  • M4 x 0.7 - 6H 4mm, flat head screws are used for the bottom halves
  • SCUF adhesive feet

Assembly

Step 1:

Open the carrying case and verify all components arrived safely, as a reminder these are the contents that are included in the kit:
1x 6063 Aluminum anodized top case
1x Brass front weight
1x Copper rear weight
1x EE-AT Hotswap PCB or W1-AT Solderable PCB
1x C3 Unified DB and JST-JST cable
1x Carry case and microfiber bag
16x 50A Tadpoles
Necessary screws, feet, and other accessories

Step 2:
Begin by taking your plate of choice and PCB. Install stabilizers and switches. 

Step 3:
Install included 50A tadpoles into the top case (5x) as the optional included force break, and the 14x required tadpoles into the holes in the PCB. 

Step 4:
Remove top case by removing the 8 screws on top and bottom edge of the board and set aside.

Step 5:
Plug JST cable into the daughterboard, it is not directional, so either way works. Install daughterboard using the 4x included M2 screws.

Step 6: 
Place completed build into the bottom case and re-install top case, using the 8  screws from Step 4.