Manta Build Guide

Step 1:

Confirm package contents:

Ensure all order items are included such as plates, pcbs and top frames. Also ensure that gaskets, feet and forcebreak sticks are in the accessories box. If any items are missing reach out to the vendor you purchased it from.  

 

Step 2:

Inspect the keyboard:

Look over board for any damage that could have happened during shipping. If there are any issues be sure to reach out to your vendor as soon as possible. 

 

Step 3:

Test the PCB:

Test the PCB using VIA and the JSON file found on the Resource Files page. If you ever need to flash the PCB, open QMK toolbox, load the .bin file, hold the reset switch for 3 seconds then click flash. Be sure to test the PCB using tweezers before building.

Step 4:

Build plate/PCB assembly:

Use your choice of stabilizers, switches and plate to assemble the internals.

Step 5:

Seperate top and bottom case:

Remove 8x case screws using hex M2 screwdriver and remove top case.

 

Step 6:

Install feet and optionally install forcebreak stickers

Install the 4x included adhesive feet onto the bottom of the keyboard. You can install the included forcebreak stickers around both the case and weight screw points. To install the ones on the weight remove the 6x screws inside the case using hex M2 screwdriver and apply the gaskets around the screw holes.

 

Step 7:

Install gaskets:

Choose one of the 3 mounting options and the hardness.
1. Gasket grommets: There are 30a (white), 60a (light gray), and 90a (dark gray). Install the 5x gaskets to the mounting points on the plate with the the large side of the gasket on the bottom.
2. Gasket socks: There are 30a (white), 60a (light gray), and 90a (dark gray). Install the 5x gaskets to the mounting points on the plate by fitting them over the entire tab. Orientation doesn't matter.

 

Step 8:

Install internals:

Plug in the JST cable to the PCB and ensure the cable sits in the channel while lowering the assembly into the case. 

 

Step 10: 

Finishing assembly:

Replace the top case onto the bottom case and re-install the 8x M2.5 case screws.

 

Other useful information: 

Hardware:

Case Screws: 4x M2.5 x 5mm long button head screws
Daughterboard Screws: 2x M2 x 4mm long socket head screws
Weight Screws: 6x M2.5 x 4mm long flat head screws
Feet: 8mm bumpons

Compatible PCBs:

Daughterboard: C5 Unified Daughterboard with 100mm JST Cable

MX PCB: Manta65-H, Manta65-S